WEB Configuration Manual
- 10 -
⚫
Setting the IP address of Interface VLAN 1 , in order to access the switch
⚫
This page is used to set the IP address of Interface Vlan 1 in the management interface of
the device. In initial conditions, the MAC address of the device, the IP address, mask and
gateway of the interface will appear on this page.
3.3 Port Configuration
If you click
Basic Setting -> Port Configuration
in the navigation bar, the
Port Configuration
page appears, as shown as below figure:
You can change the status, speed, duplex mode and flow control of a port on this page.
Note:
Port link switching might
happen if modifying port’s speed or duplex mode. Network
communication might be affected.
3.4 Auto-Shutdown
Click
Basic Setting -> auto-shutdown
in the navigation bar, the auto-shutdown page appears, as
shown as bellow: