4
3.1 Slippery Course Installation and
Disassembly
3.1.1 Slippery Course Installation
The steps are as follows:
Step 1:
Select the installation location of the device and make sure there is enough space.
Step 2:
Tilt the equipment to the right 45
°
, so that the upper part of the DIN rail seat is stuck on the DIN
rail, holding the lower end of the equipment, up slightly to rotate the equipment, the DIN rail seat can be
stuck on the DIN rail. Verify that the equipment is fixed on DIN rail
Figure 3-1-1 Slippery Course Installation
3.1.2 Slippery Course Disassembly
The steps are as follows:
Step 1:
Hold the bottom end of the equipment with one hand and the top end of the slippery course side
with the other hand, push lower end of the device to leave the DIN rail.
Step 2:
Turn the equipment clockwise and lift the equipment, removed the equipment from the DIN rail
Push
inward
Summary of Contents for InRouter301
Page 1: ...IR300 Series of Industrial Routers Quick Installation Manual Data Version V 1 1 2021 10...
Page 4: ...2 II Panel Introduction and Structural Size 2 1 Panel Introduction Figure 2 1 Equipment Panel...
Page 9: ...7 Figure 3 4 a Glue Stick Antenna Installation Figure 3 4 b Chuck Antenna Installation...
