InGateway Documentation, Release 0.0.1
4. Click
Submit
to complete the configuration of the loopback interface.
As shown in the following figure, a secondary IP address 127.0.0.2 is set for the loopback interface.
Caution: You can set a maximum of 10 secondary IP addresses for the loopback interface.
3.3.2 Network Services
3.3.2.1 DHCP
3.3.2.1.1 DHCP Server
The Dynamic Host Configuration Protocol (DHCP) uses the client/server communication model. The client
sends a configuration request to the server, and the server replies with the IP address allocated to the client
and other configuration information. In this way, the client IP address and other configuration is assigned
dynamically. You can configure a DHCP server and view its configuration on the
DHCP Server
page.
Follow these steps to configure a DHCP server:
1. Choose
Network > Network Services > DHCP > DHCP Server
to display the
DHCP Server
page.
2. Click the
Add
or
Edit
icon to configure the DHCP server.
3. Set the parameters. For details about these parameters, see
DHCP server parameter description
.
4. Click
OK
to save the configuration, and then click
Submit
to apply the configuration.
The following figure shows the DHCP server configuration.
164
Chapter 1. InGateway Documentation Site Navigation
Summary of Contents for InGateway501
Page 1: ...InGateway Documentation Release 0 0 1 zhangning Aug 24 2020...
Page 2: ......
Page 4: ...ii...
