InHand InGateway501, User Manual

Page: 111 / 204

InGateway Documentation, Release 0.0.1
– Pseudowire Class: specifies the name of an existing pseudowire class.
– Protocol: specifies the packet encapsulation protocol used on the tunnel. Options are IP and
UDP.
– Source Port: specifies the source port used to establish the L2TP tunnel when UDP is used.
– Destination Port: specifies the destination port used to establish the L2TP tunnel when UDP is
used.
– Xconnect interface: specifies the L2TPv3 bridge interface.
• L2TPv3 Session
– Local Session ID: specifies the local tunnel ID specified in static L2TPv3 tunnel configuration.
The valid value range is 1-65535.
– Remote Session ID: specifies the remote tunnel ID specified in static L2TPv3 tunnel configuration.
The valid value range is 1-65535.
– Local Tunnel ID: specifies the L2TPv3 tunnel ID set in the L2TPv3 Tunnel area.
– Local Session IP Address: specifies the IP address of the static L2TPv3 virtual interface.
4.4.3.2 L2TP Server
Parameters of an L2TP server are described as follows:
• Enable: enables or disables the L2TP server.
• Username: specifies the user name used to access the L2TP server.
• Password: specifies the password used to access the L2TP server.
• Authentication Type: specifies the authentication method used by the L2TP server. Options are Auto,
PAP, and CHAP.
• Local IP Address: specifies the virtual address of the L2TP server interface.
• Client Start IP Address: specifies the start IP address of the IP address pool on the L2TP server.
• Client End IP Address: specifies the end IP address of the IP address pool on the L2TP server.
• Link Detection Interval: specifies the interval at which the L2TP server sends link detection packets
after an L2TP tunnel is established. The valid value range is 0-32767, and the unit is second.
• Max Retries for Link Detection: specifies the maximum number of L2TP link detection failures. The
L2TP establishes a new connection after link detection fails for the maximum number of times. The
valid value range is 0-100.
• Enable MPPE: enables or disables Microsoft Point-to-Point Encryption (MPPE).
• Enable Tunnel Authentication
1.2. InGateway902 User Manual 107