InHand InGateway501, User Manual, Page: 95 / 204

InGateway Documentation, Release 0.0.1
• Version: specifies the version of the RIP protocol. Options are Default, v1, and v2.
• Network: specifies the first IP address in a network segment and the matching subnet mask.
• Advanced Options
– Default-Information Originate: enables or disables advertisement of default routing information.
– Default Metric: specifies the default cost from the local router to the destination. The valid value
range is 1-16. The value 16 indicates that the destination is unreachable.
– Redistribute Connected: enables or disables direct route redistribution to RIP.
* Metric: specifies the metric of the redistributed direct route after direct route redistribution
is enabled. The valid value range is 0-16.
– Redistribute Static: enables or disables static route redistribution to RIP.
* Metric: specifies the metric of the redistributed static route after static route redistribution
is enabled. The valid value range is 0-16.
– Redistribute OSPF: enables or disables OSPF route redistribution to RIP.Metric: specifies the
metric of redistributed OSPF routes after OSPF route redistribution is enabled. The valid value
range is 0-16.
– Distance/Metric Management:
* Distance: specifies the administrative distance of a route learned by RIP.
* IP Address: specifies the destination IP address of the RIP route.
* Netmask: specifies the subnet mask of the RIP route.
* ACL Name: specifies an access control list used for route redistribution.
* Metric: changes the metric of the route sent from or received on an interface.
* Policy In/Out: specifies the direction to which the route filtering policy is applied. Options
are In and Out.
· In: applies the access control list to incoming traffic.
· Out: applies the access control list to outgoing traffic.
* Interface: specifies the interface to which the route filtering policy is applied.
* ACL Name: specifies the name of the access control list referenced in the route filtering
policy.
– Filter Policy
* Policy Type: specifies the type of the route filtering policy. Options are access-list and
prefix-list.
* Policy Name: specifies the name of the prefix list.
1.2. InGateway902 User Manual 91