InHand InGateway501, User Manual

Page: 47 / 204

InGateway Documentation, Release 0.0.1
– ICMP Detection Timeout: specifies the timeout period of an ICMP probe. If the gateway does
not receive any ICMP Reply packet within this period, it considers that the ICMP probe times
out.
– ICMP Detection Max Retries: specifies the maximum number of retries after an ICMP probe
failure. (The gateway dials up again when the number of retries reaches this value.)
– ICMP Detection Strict: enables or disables the strict ICMP probe mode. In this mode, the
gateway does not send ICMP probe packets when its dial-up interface is transmitting data traffic.
It sends ICMP probe packets only when the dial-up interface is idle.
• Advanced Settings
– Initial Commands: specifies some AT commands used to check the module status.
– RSSI Poll Interval: specifies the interval at which the gateway checks the signal status after
dialing up successfully. For example, the interval is set to 60s. If you remove the antennas after
the gateway dials up successfully, the signal strength will remain unchanged in 60s and decrease
60s later. If the interval is set to 0, RSSI polling is disabled.
– Dial Timeout: specifies the dial-up timeout period. If the gateway fails to dial up to a network
within the timeout period, the dial-up times out. In this case, the gateway checks the module
status and dials up to the network again.
– MRU: specifies the maximum receive unit, which is expressed in bytes.
– MTU: specifies the maximum transmit unit, which is expressed in bytes.
– Use Default Asyncmap: enables or disables the default Asyncmap.
– Use Peer DNS: enables or disables the use of the DNS server assigned in the connected network.
– LCP Interval: specifies the interval at which the gateway checks whether the cellular connection
is normal.
– LCP Max Retries: specifies the maximum number of dial-up retries after the link connection is
interrupted.
– Infinitely Dial Retry: enables the gateway to retry unlimited times upon a dial-up failure.
– Debug: enables display of more detailed system logs.
– Expert Options: allows you to set command parameters.
3.3.1.2 Ethernet
The Ethernet page displays the configuration and status of Ethernet interfaces on the IG902. You can set
Ethernet interface parameters or view details about the Ethernet interfaces on this page. Follow these steps
to configure the Ethernet interfaces:
1.2. InGateway902 User Manual 43