7
6
English
Transformer
The brightness of the light is freely adjustable via the sliding
control on the transformer, which also switches the lamp on
and off.
Important:
The transformer must be sufficiently ventila-
ted and should never be covered by any object or material
likely to block air circulation.
Cleaning
Clean the lamp carefully with a feather duster or dry, lint-free
cloth. Do NOT use cleaners containing solvents.
Technical specification
100-240V~, 50/60 Hz., PF 0,9, Secondary 12V~,
5W LED, 2000-2700K, socket E27.
Electronic transformer with integrated dimmer.
The lamp comes with light source of the energy class G
(A-G).
Important:
The LED bulbs are manufactured exclusively
for Ingo Maurer GmbH. Replacements are only available
from our webshop or authorized retailers.
A defective transformer or LED bulb must be
disposed as electronic scrap, it must not get into
domestic waste.
Any repairs that may become necessary must be carried out
by a qualified electrician.
The legal and contractual warranty for defects and product
liability will be void, should the installation instructions not
be duly followed or non-original components be employed.
English
Important:
Do not connect the lamp to the power supply
until the assembly is completed.
Assembly
Take all parts carefully out of the packaging. Remove the
cable ties and unwind the cables completely.
Insert the two low-voltage plugs in the terminals on the
underside of the base. Ensure that the plugs are securely in
position.
①
Insert the brass wire (
1
) in the retaining bolt
(
2
) on the lamp base and tighten the grub screw with the
Allen key provided.
②
Inserting the light bulb
Carefully unwind the red wire (
3
) with the soldering from
the light bulb, pull it out more or less straight, thread it down
through the coil (
4
) on the brass wire and screw the light
bulb into place.
③
Loosely wind the red wire (
3
) twice around the brass wire
and insert the end in the contact (
5
) on the lamp base.
④
Straighten the red wire. Mount the brass cap (
6
) horizontally
or at a slight angle on the bulb and make sure that the cap
is securely in place. To alter the position of the cap, detach it
from the bulb and then remount it.
⑤
Changing the light bulb
Caution:
Allow the lamp to cool down completely.
Before unscrewing the spent bulb, detach the brass cap by
pulling it up and away from the bulb.
Pull the red wire (
3
) out of the contact (
5
) on the lamp
base and unwind it from the brass wire.
Fit the replacement, following the procedure described in
“inserting th light bulb”
.
Summary of Contents for I Ricchi Poveri Toto ambient
Page 1: ...I Ricchi Poveri Toto ambient Instructions...
Page 7: ...13 12 2 1...
Page 8: ...15 14 5 3 3 4 6...
