INGICS
TECHNOLOGY
BLE is normally in listening mode. It collects the messages advertised by other BLE devices.
These messages are then transferred to WiFi and sent to the cloud server configured by the user. The
packet format sent to the cloud server as below:
$<report type>,<tag id>,<gateway id>,<rssi>,<raw packet content>,*<unix epoch timestamp>\r\n
examples:
$GPRP,CCB97E7361A4,CB412F0C8EDC,-49,1309696773206D65736820233220285445535429020106
$GPRP,E5A706E3923A,CB412F0C8EDC,-87,0201041AFF590002150112233445566778899AABBCCDDEEFF0000100C3BB
$GPRP,0C61CFC1452E,E7DAE08E6FC3,-44,0201061AFF4C000215B9A5D27D56CC4E3AAB511F2153BCB9670001452ED6
(iBeacon, UUID: B9A5D27D56CC4E3AAB511F2153BCB967, Major: 0001, Minor: 452E)
*Note:
When NTP is enabled, a timestamp field is added to the packet. Check the System section for the NTP
setting.
<report type>
GPRP: general purpose report .
RSPR: active scan response report
<tag id>
MAC address or ID of tag/beacon
<gateway id>
MAC address of gateway’s BLE
<rssi>
RSSI of tag/beacon
<raw packet content>
Raw packet received by the gateway
<unix epoch timestamp>
Optional timestamp when NTP is enabled
Input and Output
Multi-function button
One multi-function button is on one side of the iGS01S as
the figure showed.
It acts as WPS, reset to default settings, and OTA (over-the-air FW
upgrade). Below is how it functions.
Function
Mode
Trigger Condition
WPS
Station
short press for over 1 sec and release
Reset to default settings
Any
long press for over 5 sec
OTA
Boot up
press then power on, keep pressing till LEDs
flash
WPS
iGS01S supports WPS to connect to your Access Point. First press the WPS button on your
INGICS TECHNOLOGY CO., LTD. • [email protected] • WWW.INGICS.COM
3
