ABW2011IQM01_C - Installation and Operation Manual
11. Operation
The main function of the charging station is to supply and measure electrical energy for users that have prior
authorization with an RFID card reader system, except in stations configured without authentication.
This section describes the operation of the charging station in detail.
11.1. Status indication
The charging station indicates its current status by means of light signals. It has independent indicators for each
power socket.
Status
Lighting
Description
Awaiting vehicle
Continuous green
The charging socket is waiting for a vehicle to be connected in order to
proceed with charging.
Awaiting charge
Flashing yellow
A user has identified a card using the reader and the socket is waiting for
the user to connect their vehicle to the station.
Charge
Continuous blue
A vehicle has been connected to the charging station.
Reduced consumption
Flashing blue
The consumption is reduced
Incident
Continuous red
There is an error in the station or the charging process is not being
performed correctly.
Standby
None
The charging station has been remotely shut down.
End of session
Continuous yellow
The charge has finished.
Card rejected
Continuous red
The card is not valid or has not been recognized.
11.2. User interface
The display is divided into two independent areas, one for each available socket.
The interface guides the user's charging process.
11.3. Charging process
Depending on the client's requirements, the charging process will start with or without authentication. The process
for each case is described below.
11.3.1. Charging process with authentication
CAUTION
The electrical supply connector must not be removed from the vehicle while the charging is being carried out.
Starting the charge process
1. Check that the charging station is in
awaiting vehicle
status with the green light.
40
Operation
Ingeteam