ABW2011IQM01_C - Installation and Operation Manual
EN
ES
FR
IT
4. Follow the instructions given by INGEREV WEB Manager.
CAUTION
Certain operating systems may reject the above URL due to their settings. In these cases, proceed as follows:
1. Connect the laptop computer to the unit's J17 or J18 connector using an Ethernet cable.
2. In a web browser access
http://192.168.1.33:8080
.
3. Follow the steps given in the browser to carry out the configuration process.
10.1.2. Local connection via Wi-Fi
By default the unit is configured in
Access Point
mode. This means that it creates as Wi-Fi network that allows
connections from devices such as laptop computers, tablets or smartphones.
To make the connection, follow these steps:
1. Connect the device to the network created by the charger. The network name will be the same as the
unit's serial number. The Wi-Fi network password is the first 8 digits of the password specified on the
sticker on the documentation delivered with the unit.
2. On the device, open the browser and open
http://192.168.2.1:8080
or
http://SerialNumber.local:8080
.
3. Enter the username and password. The username and password are specified on the documentation
delivered with the unit.
4. Follow the instructions given by INGEREV WEB Manager.
10.2. Remote connection
The purpose of remote connection is to have access to the charger when the charger and the computer are
connected to the Internet from different communication networks. The charger must be connected to the Internet
via Wi-Fi, Ethernet or 3G/4G.
To make the connection, follow these steps:
1. With the charger and the computer connected to the Internet, open the web browser and open
http://www.ingerev.com/SerialNumber
, where
SerialNumber
corresponds to the unit's serial number (for
example,
http://www.ingerev.com/6S0A182A0001)
. The serial number is the unit's unique identification
and is located on the specifications plate.
CAUTION
The URL
http://www.ingerev.com/SerialNumber
can only be used to access the charger if it has a public IP.
However, if it does not have a public IP, you will need to know the IP (
ipCargador
) in order to access it via
http://
ipCargador:8080/.
If it does not have a public IP, the computer and the charging point will need to be in the same network or APN.
2. Enter the username and password. The username and password are specified on the documentation
delivered with the unit.
39
Configuration
Ingeteam