Ingeteam INGECON SUN 1Play TL M, Installation And Operation Manual

Page: 70 / 312

3. Receipt of the unit and storage
3.1. Reception
Keep the unit in its packaging until immediately before installation. Keep the unit in a horizontal position at all
times.
3.2. Equipment identification
The serial number of the equipment is its unique identifier. You must quote this number in any communication
with Ingeteam.
The unit’s serial number is marked on the specifications plate.
3.3. Transport damage
If the unit has been damaged during transport, proceed as follows:
1. Do not proceed with the installation.
2. Notify the distributor immediately within five days of receipt of the unit.
If ultimately you must return the unit to the manufacturer, you must use the original packaging.
3.4. Storage
Failure to follow the instructions in this section may lead to damage to the unit.
Ingeteam accepts no liability for damage resulting from the failure to follow these instructions.
If the unit is not installed immediately after reception, take into account the following points in order to avoid
damage:
• The unit must be stored in its original packaging.
• The package must be stored in the horizontal position.
• Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
• Keep it away from water splashes, welding sparks, etc.
• Cover the unit with a breathable protective material in order to prevent condensation due to ambient
humidity.
• Units in storage must not be subjected to weather conditions other than those indicated in Section “2.8.
Specifications tables” .
• It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
• Do not store the unit outdoors.
3.5. Conservation
In order to permit correct conservation of the units, they must not be removed from their original packaging until it
is time to install them.
In case of prolonged storage, use dry places, avoiding, as far as possible, sharp changes in temperature.
Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum conditions before
installation. Ingeteam accepts no liability in the case of failing to observe this condition.
70
Receipt of the unit and storage Ingeteam
ABE2011IQM01_C - Installation and Operation Manual