3.4. Storage
If the unit is not installed immediately after receipt, the following points should be taken into account in order to
prevent damage:
•
The package must be stored in the position in which the box arrived.
•
Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
•
Keep away from water splashes, welding sparks, etc.
•
Cover the unit with a breathable protective material in order to prevent condensation due to ambient humidity.
•
Units in storage must not be subjected to climate conditions other than those indicated in Section “2.2.
Environmental characteristics”.
•
It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
3.5. Conservation
In order to permit correct conservation of the units, they must not be removed from their original packaging until it
is time to install them.
In case of prolonged storage, the use of dry places avoiding, as far as possible, sharp changes in temperature is
recommended.
Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum conditions before
installation. Ingeteam Energy, S.A. accepts no liability for damage in the case of failing to observe this condition.
3.6. Waste handling
During the various processes for installation, start-up and maintenance, waste is generated which must be handled
appropriately according to the regulations in the corresponding country.
At the end of the unit’s life, the waste must be processed by an authorised waste management company.
Ingeteam, in accordance with its policy of respect for the environment, will inform the authorised manager, via this
Section, of the location of components to be decontaminated.
The elements within the unit that must be handled individually are:
1.
Electrolytic condensers or condensers containing PCB
2.
Batteries and accumulators
3.
Printed circuit cards
4.
Liquid crystal displays
2
3
1
4
AAY2000IKI04
20
Installation manual
Ingeteam Power Technology, S.A.
Summary of Contents for Ingecon mWind 2.5
Page 1: ...Ingecon Wind Installation manual...
Page 55: ...Notes...
