28
Operation
Ingeteam
ABA2013IQM01_ - Installation and usage manual
4.
A screen will be displayed with a flashing connector. Connect the cable to the required electrical socket.
5.
Once the vehicle is connected to the station, the deferred time selection screen will be displayed. The
pre-set time recorded on the card appears, but can be changed to any required time.
SELECT STARTING TIME
21
SELECT STARTING TIME
21
When viewing the deferred charge time selection screen the time appears highlighted with a black background. To
return to the option selection menu, press the
button. To adjust the time, press the
or
buttons until the
required time is displayed. Press
to switch to selecting the minutes in the same way as for the hours, and when
this is complete press
to adjust the seconds. Once these have been selected press
again. The following
information screen will be displayed:
CHARGING
CHARGING
When the charge start time is reached the charge will be
carried out.
6.
When the set charge start time is reached the station will show the following screen indicating that the
charging process has started correctly.
CHARGING
CHARGING
Ending the charge process
7.
To finish the charge cycle identify the card using the reader. The station interrupts the electrical supply
and unlocks the type 2 connector in the event that it has been used.
8.
Pull out the connector.
The station will return to the
awaiting vehicle
status.
Loss of supply (immediate charge and deferred charge)
When faced with a loss of electricity supply during the charging process the station automatically unlocks the type
2 connector, in the event that it was selected, and it remains inactive until the supply is restored.
After the supply is restored the station automatically restarts and switches to the status active before the supply
was lost.
9.2.2. INGEREV GARAGE Basic
The electrical supply connector must not be removed from the vehicle while the charging is being
carried out.
