18
Installing and connecting the unit
Ingeteam
ABA2013IQM01_ - Installation and usage manual
7.3.2. Connecting the power to the unit
Cabling requirements
The connection must meet certain requirements:
Connection specifications
Connection type
Single phase
Number of conductors
2P + E
Nominal current
16 A
Conductor maximum diameter
10 mm
2
(2 x 6 mm
2
)
Wiring process
In order to connect the unit it is not necessary to open its front enclosure. A window is located at the bottom of the
unit, to access the terminal block to which to make the connection.
Upon receiving the unit the cover of this window is not installed.
1.
Insert the power cable through the packing gland located on the cover of the bottom window. Screw the
packing gland to the cover.
2.
Connect the power cables to the terminal block as shown in the following figure. The terminal blocks are
clamp type. Insert a flat-head screwdriver to free it and insert the cable in the indicated hole. Tighten it using
the screwdriver.
T L N
T: Ground
L: Live
N: Neutral
