Ingersoll-Rand XHP1070WCAT, Operating & Maintenance Manual, Page: 58 / 91

Operating & Maintenance Manual Maintenance
58 Book: 22742944 (3-17-06) Rev. A
The battery restraint should be kept tight enough to prevent the battery from moving.
Pressure System
Regularly, it is necessary to inspect the external surfaces of the system (from the airend
through to the discharge valve(s)) including hoses, tubes, tube fittings and the separator
tank, for visible signs of impact damage, excessive corrosion, abrasion, tightness and
chafing. Any suspect parts should be replaced before the machine is put back into service.
Tire Pressure
See the GENERAL DATA SECTION of this manual.
Running Gear/wheels
Check the wheel nut torque 20 miles (30 kilometres) after refitting the wheels. Refer to the
TORQUE SETTING TABLE later in this section.
Lifting jacks should only be used under the axle
The bolts securing the running gear to the chassis should be checked periodically for
tightness (refer to the MAINTENANCE CHART for frequency) and re-tighten where
necessary. Refer to the TORQUE SETTING TABLE later in this section.
Lubrication
CAUTION
!
Always check the oil levels before a new machine is put into service.
If, for any reason, the unit has been drained, it must be re-filled with new oil before it is put
into operation.
Engine Lubricating Oil
The engine oil and oil filter element should be changed at the engine manufacturer's
recommended intervals. Refer to the Engine operator manual/section.
Refer to the Engine operators' manual/section for engine oil specifications.