Ingersoll-Rand Thermo King TracKing, Installation Manual

Page: 14 / 47

12
Precedent Units Step 3 - REB Installation
REB Installation
1. Open the control box door and install the REB module onto the
controller with the supplied hardware.
• Be sure pins are aligned correctly and are not bent.
• When installing the REB mounting hardware, be careful not to
pinch or damage the GPS antenna wire attached to the circuit board.
• REB mounting hardware requires a two-step torque process:
Step 1: Torque to 1.4 N•m (12 in-lbs.)
Step 2: Loosen and re-torque 1.4 N•m (12 in-lbs.)
Battery Harness Installation
2. Connect the battery harness 4-pin connector to the 4-pin connector
(BVP-01, BVN-01) on the REB.
Antenna Cable Installation
3. Attach the antenna cables to the REB. Make sure the antenna and REB
labels match.
• Torque to 1.4 N•m (12 in-lbs.)
4. Support the antenna wires by securing them to the control box with
bandwraps. This will help prevent undue vibration.
CAUTION: When working with electronic circuits that contain
microprocessors, always wear an electrostatic discharge (ESD)
wrist strap. Connect the grounding clip to the chassis ground or
CH terminal to prevent electrostatic discharge from damaging
circuits.