Ingersoll-Rand MHP825WCAT, Operation & Maintenance Manual

Page: 105 / 109

Parts Ordering Operation & Maintenance Manual
103
In referring to the rear, the front or to either side of the unit, always consider the drawbar end
of the unit as the front . Standing at the rear of the unit facing the drawbar (front) will determine
the right and left sides.
Fasteners
Both SAE/inch, ISO/metric hardware have been used in the design and assembly of these
units. In the disassembly and reassembly of parts, extreme care must be taken to avoid
damaging threads by the use of wrong fasteners. In order to clarify the proper usage and for
exact replacement parts, all standard fasteners have been identified by part number, size and
description. This will enable a customer to obtain fasteners locally rather than ordering from
the factory. These parts are identified in tables that will be found at the rear of the parts
illustrations. Any fastener that has not been identified by both part number and size is a
specially engineered part that must be ordered by part number to obtain the exact replacement
part.
Markings and Decals
NOTICE
Do not paint over safety warnings or instructional decals. If safety
warning decals become illegible, immediately order replacements from
the factory.
Part numbers for original individual decals and their mounting locations
are shown within Parts List Section. These are available as long as a
particular model is in production.
Afterwards, service sets of exterior decals and current production safety warning decals are
available. Contact the Product Support Group at Mocksville for your particular needs and
availability.