Ingersoll-Rand LT6K, Operation And Maintenance Manual, Page: 12 / 37

Safety
23201387 (03/05) 11 Lightsource LT6K
Operation and Maintenance Manual
Do not extend, retract or use tower unless it is in a
VERTICAL position with latch and lock pin securely in
place.
DO NOT climb on tower. Perform repairs and
adjustments with the tower in the down (transport)
position.
When tower is pivoting during raising and lowering, be
certain anti-telescope latches are engaged. Failure to
do this may result in uncontrolled tower extension and/
or tower collapse.
Figure 3
When tower is telescoping during raising and lowering,
be certain anti-pivot latches are engaged. Latches must
remain engaged any time the tower is vertical and
extended. Failure to do this may result in uncontrolled
tower extension and/or tower collapse.
Damaged cables may break during tower operation
allowing the tower to fall. Do not operate tower with
damaged cables. Replace damaged cables.
Lamps
Inspect lamps and replace broken or missing lamp lens
or punctured glass bulbs. Do NOT operate lights with
broken or missing lens or broken glass bulb.
Flammable Fuels
Do not fill fuel tank when engine is running.
Do not smoke or use an open flame in the vicinity of the
generator or fuel tank.
Do not permit smoking, or open flame, or sparks to
occur near the battery, fuel, cleaning solvents or other
flammable substances and explosive gases.
Thoroughly clean up any fuel spills occurring inside this
unit.
Volatile Substance
Ether is extremely volatile. Do NOT use in conjunction
with the “Glow plug” PREHEAT system furnished on
this engine.