SKYZER TECHNOLOGIES
PAGE 69 OF 140
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
7 TERMINAL MANAGEMENT SYSTEM (TMS)
The terminal can be configured to receive software updates from the Skyzer
TMS. This feature is provided solely to allow the terminal to be remotely
upgraded.
7.1 TMS Configuration
TMS Configuration must be completed to enable the terminal to download
software upgrades via Broadband, GPRS and WIFI.
TMS is not available over dial-up
7.1.1
TCP/IP (Broadband) and WiFi Configuration
Step
Terminal Display
Comment
1.0
Press
FUNC
2.0
FUNCTION?
Enter
2467
and press
ENTER.
3.0
TMS CONFIG
ENTER OR CLEAR
Press
ENTER
to configure the TMS parameters,
CLEAR
to cancel and exit to idle
prompt.
4.0
TMS TERMINAL ID?
XXXXXXXX
This parameter specifies the TMS Terminal ID which is by default the last 8 digits of
the terminal serial number.
6.0
TMS NII
201
This parameter specifies the Network International Identifier that the terminal uses
to route messages to TMS. Press
ENTER.
7.0
TMS URL
www.skyzertms.co.n
z
This parameter specifies the TMS URL. By default is set to
www.skyzertms.co.nz
. Press
ENTER.
8.0
PRIMARY
HOST IP ADDRESS
103.216.132.29
This parameter specifies the Primary Host IP Address. By default it is set to
103.216.132.29
. Press
ENTER.
9.0
PRIMARY
HOST PORT
3200
This parameter specifies the Primary Host Port number. By default is set to
3200.
Press
ENTER.
10.0
SAVE CONFIG Y/N
Press
ENTER
to save the configuration or
CLEAR
to exit without saving
configuration.
