INGENIA Triton Go, Product Manual, Page: 67 / 119

Triton Go Product Manual | Wiring and Connections
INGENIA | 05/29/2017 67
Next figure illustrates how to connect the digital halls to the Triton Go Servo Drive. Refer to Feedback wiring
recommendations
(see page 78)
for more information about connections and wires.
7.4.2 Analog Halls interface
The Triton Go Servo Drive can operate with analog Hall sensors (also known as linear halls) as feedback option.
Signals provided by these sensors are typically 5 V peak-to-peak sinusoidal signals, with 2.5 V offset and a phase
Velocity control with Halls
Due to inherent low resolution of motor mounted Hall sensors, they are not recommended for velocity
feedback in low speed applications.
