Ingecon SUN 125 TL U 208 Outdoor, Installation Manual, Page: 26 / 88

ABB2000IKI01
26
Installation manual Ingeteam
Transport using a crane
When moving with a crane, use the strips supplied for this purpose. To access these:
1. Remove the side roofs of the unit by removing the 4 bolts on each side as shown below:
2. Turning the lateral metal sheet will reveal the strips supplied for moving the unit with a crane. Remove them
and place them as shown in the figures below, anchoring them with the bolts supplied.
3. Anchor the unit with ropes at the points shown.
Ensure that the load is distributed evenly between these points. Ensure this by fixing individual cables, chains or ropes
to each of the points, taking into account that the angle formed by each pair of cables on the same side is less than
or equal to 45° and ensuring that the cables are as vertical as possible.
It is always advisable to use a load frame as in the adjoining figure for a proper distribution of the loads, bearing in
mind that the angle
φ
should be equal to 90°.
φ
3.5. Storage
If the unit is not installed immediately after receipt, the following points should be taken into account in order to
prevent damage:
• The package must be stored in the vertical position.
• Keep the unit free of dirt (dust, shavings, grease, etc) and away from rodents.
• Keep away from water splashes, welding sparks, etc.
• Cover the unit with a breathable protective material in order to prevent condensation due to ambient humidity.
• Units in storage must not be subjected to climate conditions other than those indicated in Section “2.1.8.