Infortrend EonStor CS 3016, Installation Manual

Page: 17 / 86

EonStor CS Installation Guide
page 17 / 86
Installation Guide
1-4. JBOD connections (Optional)

Setup the JBOD Expansions

Locate
the rotary ID switch on the JBOD’s front panel.

Use a small flat blade screwdriver to set a unique ID on the JBOD expansion system.
IMPORTANT! When setting an ID on the JBOD system, you must start from 1. Use the same JBOD
models if you want to attach more storage expansions. Refer to CS Expansion Guide for more
information

Install the new expansion enclosure to the rack
Click here for more information about installing the new expansion enclosure to the rack

Connecting JBOD Expansions (Example)

Connect CS onboard SAS IN port to the OUT port on the expansion enclosure.

Connect expansion enclosure (1) SAS IN port to the OUT port on the expansion enclosure (2).
The following picture shows the example for connecting CS 3016 with JB 3016