Multitron Standard - Operating Manual
Operation
Page
74
of
114
17 March 2021
INFORMATION
Do not set the timer to
ON in the “FT” phase. This will activate cy-
clical operation.
The device will now run using the setpoints set for the first phase un-
til the set time elapses. The
Timer active function symbol will flash for
the duration
.
As soon as the set time has expired, the system will change to the
second phase. The
Timer active function symbol will go out. The de-
vice will now run with the setpoints set for the second phase until it
is switched off manually or the setpoints are modified.
INFORMATION
The timer function can be deactivated at any time by switching off
the timer. The device will then continue running with the last ac-
tive parameter settings.
6.5.3
Programming a Cyclical Change
Programming the timer for a cyclical change is a multi-step proce-
dure:
a)
Set the setpoints (RPM and/or °C) for the first phase using the
F
button and activate the parameters.
b)
Set and activate the timer for the first phase using the
F
but-
ton.
c)
Set the setpoints (RPM and/or °C) for the second phase using
the
FT
button and activate the parameters.
d)
Set and activate the timer for the second phase using the
FT
button.
