InfoPrint 6500-v05, User Manual

Page: 43 / 340

EJECT key moves the paper forward to the tear–off position. In the
NOT READY state, pressing the EJECT key moves the paper
forward to the tear–off position. Pressing one of the following keys
has the function described below:
EJECT Moves the paper to its next available position. The printer
returns to the mode it was in before
EJECT was pressed.
START
Moves the paper to its next available position and places
the printer in the
READY state.
STOP
Moves the paper to its previous position and places the
printer in the
NOT READY
state.
Program Mode
The printer is in Program mode whenever the configuration menus and option
values are displayed on the operator panel message display. Program mode is
either locked or unlocked. In order to select new configuration values, you must
unlock Program mode. In order to prevent accidental changing of the configuration
settings, you may lock Program mode.
Unlocking The Program Mode
To use the operator panel to change the configuration settings, Program mode
must be unlocked. When Program mode is unlocked, pressing the
Enter
key selects
configuration values as the active values, that is, places them into printer DRAM.
An asterisk (*) after a displayed setting shows it is entered into memory.
Press the Enter keys at the same time to unlock Program mode. The
following message will appear briefly:
OPERATOR MENU
UNLOCKED
Chapter 3. Configuring the Printer
27