InfoPrint 6500-v05, User Manual

Page: 262 / 340

Table 11. Fault Messages (continued)
Fault Message
Operator
Correctable?
Explanation Solution
H/B CONTROL MODE
SEE USER’S MANUAL
N/A A status message indicating
that one or more hammer
coils are hotter than normal
and the printer will run in
half–speed mode until they
cool down. This can occur
during especially dense print
jobs. None required. The printer
automatically corrects the
condition by running at
half–speed mode until the
hammers cool down, at which
point it resumes full speed
printing.
HMR BANK NOT INSTALLED
SEE USER’S MANUAL
No Hammer bank is not
installed. Contact your InfoPrint
Solutions Company service
representative.
HAMMER COIL BAD
#, #, #, #,...etc.
No Hammer coils(s) number #,
#, etc. failed the current test
at power-up. (You can continue to print with
degraded print quality.)
Contact your InfoPrint
Solutions Company service
representative.
ILL INST ACCSS* Yes Illegal Instruction Access: a
firmware error on the
controller board. Cycle power. Run the print job
again. If the message appears,
download the emulation
software again. If the message
appears, contact your InfoPrint
Solutions Company service
representative.
INCOMPAT E-NET Yes Incompatible Ethernet
interface card is installed. Install a compatible Ethernet
interface card to the printer
then reboot. If this message still
appears, contact your InfoPrint
Solutions Company service
representative.
INTAKE FAN FAULT Yes Sensors cannot detect current
in fan circuit. See description for HMR
BANK FAN FLT.
INTERRUPT UNUSED VECTOR
00 No The controller board receives
an interrupt it does not
understand. Cycle power. If this message
occurred once and never again,
you can ignore it. If the
message reappears or appears
consistently, contact your
InfoPrint Solutions Company
service representative.
LOADING PROGRAM FROM
PORT
XX %
N/A The new emulation program
is loading into printer RAM.
XX % indicates how much of
the program has loaded.
No action required.
LOADING PROGRAM INTO
FLASH N/A The printer has deleted the
previous program from flash
memory and is loading the
new program into flash
memory. No action required.
NOT READY N/A Printer state message: printer
is offline, not in
communication with host. No action necessary.
246
InfoPrint 6500-V User’s Manual