InfoPrint 6500 DBCS, User Manual

Page: 89 / 230

IEEE 1284 Menu
89
IEEE 1284 Menu
The IEEE 1284 interface is configured using the following configuration
options.
Buffer Size in Kbytes
This parameter determines the size of the input buffer. Up to 256K are
available.
•
64 (the default)
•
1 – 256
Auto Trickle
Auto Trickle is used to prevent a host computer from timing out because the
parallel interface was busy for too long. When Auto Trickle is enabled and the
printer's buffers are almost full, the printer will begin to trickle data in (at the
rate set in the Trickle Time menu) until the buffers start to empty out.
IEEE 1284
(from page 84)
Buffer Size in
Kbytes
Auto
Trickle
Disable*
Enable
Trickle
Time
1/4 sec*
1/2 sec
1 sec
2 sec
4 sec
8 sec
16 sec
OFF
* = Factory Default
64*
(1-256)
To cycle through the menus and its
options, press
MENU then:
To enter a menu or select menu options,
press
ENTER .
To return to a previous menu level,
press
RETURN .
To exit the configuration menus
and return to READY, press START .
Scroll/
Micro Scroll/
Micro
OR
Serial Interface Menu