InfoPrint 6500 DBCS, User Manual

Page: 171 / 230

Fault Correction Procedure
171
LOADING PROGRAM
FROM PORT XX% N/A The new emulation
program is loading into
printer RAM. XX%
indicates how much of
the program has loaded. No action required.
LOADING PROGRAM
INTO FLASH
N/A The printer has deleted
the previous program
from flash memory and
is loading the new
program into flash
memory. No action required.
NOT READY N/A Printer state message:
printer is offline, not in
communication with
host. No action required.
ONLINE
CU TIMED OUT
No Controller unit timed out. Contact your InfoPrint
service representative.
OPERATOR MENU
<first menu item>
N/A Non–error status
message. No action required.
OPERATOR MENU
LOCKED N/A Non–error status
message. No action required.
OPERATOR MENU
UNLOCKED N/A Non–error status
message. No action required.
P00 ERROR:SYSTEM
FAULT Yes Firmware error on the
controller board. Cycle power. Run the
print job again. If the
message appears,
download the emulation
software again. If the
message appears again,
contact your InfoPrint
service representative.
P05 DIAGNOSTIC TEST
PASSED N/A Non–error status
message. No action required.
P17 SECURITY VIOLATION No Security key on
controller board does not
match code of firmware
on the controller board. Contact your InfoPrint
service representative.
PA1 SELECTED N/A Attach status message. No action required.
PA2 SELECTED N/A Attach status message. No action required.
Table 8: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution
Fault Messages