InfoPrint 6500 DBCS, User Manual

Page: 148 / 230

148
Chapter 6
Fault Messages
169 ERROR: PROGRAM
NOT COMPATIBLE No The printer is not
compatible with the
downloaded program. Contact your InfoPrint
service representative.
170 ERROR: PROGRAM
NOT VALID No The printer does not see
a program in flash
memory. Contact your InfoPrint
service representative.
171 ERROR: SHORT AT
ADDRESS XXXX No Hardware failure in
DRAM or controller
circuitry. Contact your InfoPrint
service representative.
172 ERROR: WRITING TO
FLASH No Hardware or software
fault in flash memory. Contact your InfoPrint
service representative.
173 ERROR: WRONG
CHECKSUM No The printer received the
complete program but
the checksum did not
match. Contact your InfoPrint
service representative.
174 ERROR OCCURRED
FLUSHING QUEUES* No An interim message that
displays while the printer
discards host data it
cannot use because a
fault condition exists. Contact your InfoPrint
service representative.
175 ACCESS NULL
POINTER*
SEE USERS MANUAL
No Application software
tried to perform an illegal
printer function or
damaged logic circuits
were detected on the
controller board. Contact your InfoPrint
service representative.
180 ETHERNET ADDRESS
ADAPTER NOT INSTALLED
Yes The Ethernet PCBA did
not initialize correctly. Install the Ethernet
Address Adapter.
181 ETHERNET ADAPTER
BEING INITIALIZED
N/A Status message
indicating that the
Ethernet Interface is
processing the boot
procedure. No action required.
182 ETHERNET DETECTED N/A Status message
indicating that the
Ethernet Interface has
established
communication. No action required.
190 SECURITY ERROR
SEE USERS MANUAL
No Security Key intended
for ribbon use installed
on CDB machine. Contact your InfoPrint
service representative.
Table 8: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution