InfoPrint 6500 DBCS, User Manual

Page: 138 / 230

138
Chapter 6
Fault Messages
004 VIEW FORMS
PRESS VIEW KEY
Yes Non–error status
message. Press the VIEW key to
return paper to print
position.
006 HOST SYSTEM
REQUESTS ATTN Yes Host attention message. The host computer or
printer controller requires
attention.
007 FM HEADER ERROR No Frame Header Error.
Application software has
violated header
parameters. Contact your system
administrator.
008 HOLD PRINT TIMEOUT
PRESS START
Yes Printer was off–line more
than 10 minutes and the
“Intervention Required”
parameter is set to
“Send to Host.” Press START to put
printer in READY state.
009 INVALID KEY PRESS Yes Appears briefly if an
inactive key is pressed in
current print mode. Re–enter the value, or
press the correct key.
010 PARAMETER ERROR No Illegal parameter value
received in command
code. Contact your system
administrator.
012 STRUCTURED FLD
ERROR No Applications software
has violated structured
data field parameters. Contact your system
administrator.
021 PRINT BUFFER
OVERRUN Yes Receive overrun (serial
interface). Check printer serial port
configuration setup.
Ensure that baud rate
matches both host and
printer settings.
024 SERIAL LINE PARITY
ERROR Yes Parity error. Check printer serial port
configuration setup.
Ensure that parity setting
matches both host and
printer settings.
025 FRAMING ERROR
VERIFY CONFIGURATION
Yes Framing error. (Serial
interface) Check printer serial port
configuration setup.
Ensure that it matches
host setting.
026 HEX DUMP MODE N/A Printer attach status
message. No action required.
Table 8: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution