InfoPrint 6500 DBCS, User Manual

Page: 105 / 230

Print Format Menu
105
Print Quality
NOTE: When using bold or emphasized printing, the printer prints two dots
instead of one to produce the desired effect. This does not affect
characters per inch.
This parameter specifies the density (quality) of printing:
•
LQ (the default for Hangul and Big5)
•
NLQ (the default for GB)
•
Normal
•
Hi-Speed
•
Super Hi-Speed
•
Ultra Hi-Speed
NOTE: Receipt of a data stream control sequence that changes the print
quality overrides the print quality specified via the operator panel.
High Density
This selection only takes effect on LQ typeface. The legal values are
“ENABLE” and “DISABLE”. The default value is “DISABLE”. When it is set to
“ENABLE”, it allows the LQ typeface to print in higher print density. It will not
take effect when other typefaces are selected.
Graphics Spd Up
This menu is used to increase (speed up) graphic printing speed by turning on
the Enhanced/Turbo mode.
•
Normal (the default). The printer prints at the given input graphics
resolution.
•
Enhanced . The printer provides first-level speed up, which means the
speed is faster than Normal mode.
•
Turbo . The printer provides second-level speed up, which means the
speed is faster than Enhanced mode.
•
Match Typeface . The input 180x180 dpi graphics resolution will drop-dot
to the resolution which matches the typefaceselected.
Print Character Table
This parameter prints out a table of the current interface character set.
Print Attributes
The PRINT ATTRIBUTES parameter is used to determine character and
page formatting.