InFocus LNS-W01 Replacement Instructions Manual Download Page 1

- 1 -

LCD PROJECTOR

LENS REPLACEMENT AND INSTALLATION PROCEDURES

CAUTION

When installing or replacing the Projection Lens, refer to this manual. For

installation of the lens, use the parts designated in the manual. Do not use the

installation manual and Light-Block Sheets in the lens package.

Check the following parts supplied to this projector.

NOTES ON LENS INSTALLATION

Lens installation and replacement should be made by the qualified service
personnel.

Be sure to install the lens following this procedure precisely.

Do not touch or remove any parts except the lens and related parts. It may
result in malfunctions, electrical shock, fire hazard  or other accidents.

Before installing or replacing the lens, check that the Model No. of the
Projection Lens matches to the projector.

When moving or setting up the projector, be sure to replace the Lens Cover
to protect the surface. And be careful not to hold or subject the lens to
strong forces. It may damage the lens, cabinet, or mechanical parts.

For details of the lens and installation, contact the sales dealer where you
purchased the projector.

●  

LIGHT-BLOCK SHEETS  3 pcs.

●  

LENS MOUNTING ADAPTERS  2 pcs.

●  

ADAPTER SCREWS  8 pcs.

1AA6P1P2922-- (MV6A) a

This projector applies the Projection Lenses listed below. Use the suitable lens for

where the projector is used.

✳ 

For installing those lenses, attaching Lens Mounting Adapters or removing Guide Pins is
required. Make sure the Model No. of the lens and the installation procedure on next pages
and be sure to install the lens precisely.

Model NO.

LNS-W01

LNS-W01Z
LNS-T01

LNS-T01Z
LNS-T02
LNS-W02

LNS-W02Z

LNS-M01

LNS-M01Z
LNS-S01

LNS-S02

LNS-S02Z

Type

Fixed Short Throw Lens

Fixed Long Throw Lens

Long Throw Zoom Lens

Short Throw Zoom Lens 

I

Semi-Long Throw 

Zoom Lens

Standard Zoom Lens 

II

Standard Zoom Lens 

I

Zoom

Motor Driven

Fixed

Manual

Focus

Fixed

Motor Driven

Motor Driven

Motor Driven

Motor Driven

Manual

Motor Driven

Motor Driven

Motor Driven

Motor Driven

Motor Driven

AVAILABLE LENS

LNS-W03

LNS-S03

Short Throw Zoom Lens 

II

Standard Zoom Lens 

III

Fixed

Manual

Motor Driven

Motor Driven

Summary of Contents for LNS-W01









Reviews: