Page 25
INF7012 Series Hardware Guide
TROUBLESHOOTING
SYMPTOM
POSSIBLE SOLUTIONS
No power
• Verify the power cord is properly connected to the power outlet and to
the display.
• Verify the power switch is ON and that the Power button on the remote or keypad has
been turned on (the front LED should be green).
• Plug another electrical device to the power outlet to verify that the outlet is supplying
the proper voltage.
The display shuts down suddenly
• Verify that a source is active.
• The display may have overheated. Remove any objects blocking the vents.
• Review the Windows power settings of the display.
No image
• If attempting to display an external source, see “No image from external source” below.
• Verify that the display is turned on (the front LED should be green).
• Verify that the display's PC is turned on (the PC LED on the back of the display should be
solid green).
No image from external source
• Verify that connections between the source and the display have been
made correctly.
• Verify that the cables are in good condition.
• Verify the correct input source is selected and that the input signal is compatible with
the display.
The colors on the display do not look
right
• Adjust the color settings in the Picture menu.
• Reset the picture settings.
• Verify that connections between the source and the display have been made correctly.
• Verify that the cables are in good condition.
No touchpad activity with external
computer
• Verify that the USB B to USB type A cable is plugged from the laptop into the display
correctly.
• Verify that the laptop’s operating system is Windows® 7 or 8. (The display touchpad does
not support any other operating systems.)
Touchpad functions are not
functioning consistently
• Remove all objects placed on the lip of the display and/or within 2” of the touchpad
screen.
• Disable the PiP feature.
• Power the display off and back on after a few seconds. Re-booting the display helps the
touchpad to re-synchronize.
Remote is not working
• Make sure the batteries are installed in the proper orientation and are not dead.
• Verify the remote is turned on (the button is on the bottom of the remote).
• Verify you are pointing the remote at the table and are within 26’ (8m) and 30 degrees
(horz/vert) of the sensor.
• Verify that the IR Control setting in the Advanced Option OSD menu is set
to Normal.
