InfiRay AT300 Series, Quick Start Manual

Page: 17 / 18

Precise Body Temperature Measurement Thermal Camera
责任 进取 敏行 合作
400-998-3088 www.IRaytek.com
IRay sensing
®
All Insight
- 16 -
6
、
Maintenance
6.1 Notice

Make sure the camera is fixed firmly when the camera is installed on wall, ceiling or pillar.

The camera shall not fall on the equipment, especially vigorous vibration equipment. Keep
the camera away from the presence of magnetic field interference, avoid mounting camera
to the surface where occurs vibration or shocks easily.
（
The camera may be damaged
ignoring this item
）
.

The camera lens shall not be aimed at the high temperature target such as sun, incandescent
light etc., or it may damage the lens or detector.

Equipment used indoors should not be installed exposed to rain or very wet areas.

Do not place the equipment in an environment with corrosive gas, which may cause damage
to the equipment.

Avoid placing equipment in the area where has direct sunlight, poor ventilation, or near heat
sources such as heaters (ignoring this can lead to fire hazards).

Please keep all original packing materials of the equipment properly, so that in case of any
problem, use packing materials to pack the equipment and send it to the agent or return it to
the manufacturer for treatment. IRay shall not be responsible for any accidental damage in
transit caused by materials other than the original packaging.
6.2 Cleaning and Maintenance

Do not use cleaning products that corrode or scratch optical glass components.

The germanium window surface is coated with anti-reflection coating, dust, grease,
fingerprints will produce harmful substances and lead to its performance decline or cause
scratches, once found dirt, please follow the following methods.
1) Use a blown balloon or a soft brush to clean the lens surface and avoid dust particles
scratching the anti-reflection film on lens surface during the wiping process.
2) Use soft cotton cloth or lens wiping paper to dip in alcohol or lens wiping liquid, gently
wipe the lens surface from the middle to the edge, pay attention to do not squeeze the lens surface,