Infinova
51 Stouts Lane, Monmouth Junction, NJ 08852 U.S.A. www.infinova.com
Tel: 1-888-685-2002 (USA only) Tel: 1-732-355-9100 Fax: 1-732-355-9101 [email protected]
V2.0 1002
INFINOVA
CCTV VARI-FOCAL LENS MANUAL
V1121-308, V1122-308, V1123-308, V1121-2812, V1122-2812, V1123-2812,
V1121-550, V1122-550, V1123-550, V1121-20100, V1122-20100
Thank you very much for purchasing this Infinova CCTV lens.
In order to understand the lens specifications and performances, please read this manual thoroughly. Please handle the lens with care.
MOUNT TYPE
CS mount is equipped with Infinova CCTV lens as follow. Before you use the lens, please make sure that the mount type matches that on your camera.
CS MOUNT
V1121-308, V1122-308, V1123-308, V1121-2812, V1122-2812, V1123-2812, V1121-550, V1122-550, V1123-550, V1121-20100, V1122-20100
INSTALLATION ON CAMERA
The lens can be installed by screwing it clockwise into CS-mount on the CCTV camera. Once the lens is screwed in completely to its mechanical stop position,
you will then be able to rotate lens chassis back to suit the set-up position of the camera.
WIRING DIAGRAM
Please read the user’s manual for the devices such as the camera and controller before wiring. Then please follow the chart below to insure the right connection.
V1123-308, V1123-2812, V1123-550
V1122-2812, V1122-550, V1122-308, V1122-20100
Cable
Red--------Power Supply Black-----GND
White-----VS or V signal Shield-----GND
Cable
Orange------Control (-) Yellow------Control (+)
Red----------Drive (+) Black--------Drive (-)
*Connecting Red (Power Supply) and Black (GND)
Cables in the other way to the camera by mistake may
Cause the failure of the lens internal circuit.
*When adding plus Voltage to Drive (+). Will move to the opening
direction.
IRIS
V1122-308, V1122-2812, V1122-550, V1122-20100 if the camera has a selection switch between Video and DC. Please set it to DC.
V1123-308, V1123-2812, V1123-550 if the camera has a selection switch between Video and DC. Please set it Video.(LEVEL ADJUSTMENT)
LEVEL ADJUSTMENT
MONITOR SCREEN
V1123-308 V1123-2812,
V1123-550
To Make Brighter
Rotate C/W
Rotate counter C/W
To Make Dimmer
Rotate counter C/W
Rotate C/W
*C/W = clockwise
The video signal level is continuously adjustable from Low to High. If the brightness of the monitor screen dose not appears natural, please adjust the level as
instructed.
Automatic Light Compensation (ALC) and level adjustment (LEVEL) can be accomplished by rotating the respective screws a couple of times until the optimal
image is obtained. (ALC ADJUSTMENT)
ALC ADJUSTMENT
LIGHT MEASUREMENT
V1123-2812, V1123-550
V1123-308
Setting exposure to “Peak” light
Rotate counter C/W
Rotate C/W
Setting exposure to “Average” light
Rotate C/W
Rotate counter C/W
*If any hunting is observed on the screen, set ALC to average exposure image.
*C/W=clock wise
TO INSURE LONG TERM USE
*Please remove dust on the lens by using a blower or soft brush. Avoid touching the lens surface.
*In order to remove fingerprints or oil stains on the lens surface, use lens cleaning paper or clean cotton cloth with a little cleaning liquid. Then, wipe off the
stains lightly starting from the center of the lens surface. Please wipe the lens body with a silicon cloth. Avoid usin
g any organic solvents such as thinner or benzene.
SPECIFICATION
MODEL
V1121-308, V1122-308
V1123-308
V1121-2812, V1122-2812
V1123-2812
V1121-550, V1122-550
V1123-550
V1121-20100
V1122-20100
Imager Size
1/3
″
Focal Length
3.0-8mm
2.8-12mm
5-50mm
20-100mm
MANUAL IRIS
F 1.0~CLOSE
F 1.4~CLOSE
F 1.4~CLOSE
F 1.6~CLOSE
Aperture
Range
AUTO IRIS
F 1.0~360
F 1.4~360
F 1.4~ CLOSE
F 1.6~360
Horizontal
(TELT) 36.0°, (WIDE) 91.0°
(TELE) 24.1°, (WIDE) 97.4°
(TELE) 5.6°, (WIDE) 53.6°
(TELE) 2.8°, (WIDE) 13.6°
Angle of
View
Vertical
(TELT) 27.0°, (WIDE) 67.0°
(TELE) 18.1°, (WIDE) 72.5°
(TELE) 4.2°, (WIDE) 40.3°
(TELE) 2.1°, (WIDE) 10.2°
Mount-Type
CS
Dimension 40.2mm 54.6mm 59.2mm 110mm
