Infinity S601 Profile, Manual

Page: 54 / 64

53
Ordercode: 41507
Infinity S601 Profile
Replacing a Gobo From the Rotating Gobo Wheel
Fig. 10
01)
Before removing the top part of the housing, make sure that the moving head is in the horizontal
position. The lens position should be on the bottom, symmetrically speaking.
02) Loosen all the four screws on the back of the housing.
03) Gently tilt the head so that the small metal housing slides out easily.
04) Turn the gobo wheel until you reach the gobo which you want to remove.
05) Gently lift up the gobo holder 10º and then gently pull out the gobo from its position.
Fig. 11
06) Very carefully take the gobo out of the gobo holder with a pair of pliers.
07) Place the new gobo in the gobo holder. Carefully put the pinchcock back, gently press the
pinchcock a little bit together. To do it, you can use a pair of pliers.
08) Put the gobo holder back. At first, you will notice some resistance which is caused by the way in
which the holder was built.
09) Replace the maintenance caps and fasten all the screws.