Congratulations on purchasing your Infinity Router Table
Extension Wings. These wings are designed to mount to the
Infinity Heavy-Duty Tool Stand and Infinity Plycore Router Tabletop.
Installation is best done by flipping your router table upside down. We
recommend placing the top on a sheet of cardboard or similar surface to avoid
scratching or damaging your table.
Parts List
A.
8x Pivot Arms
B.
4x Pivot Arm Connectors
C.
4x Z-brackets
D.
4x Table Brackets
E.
16x 1/4-20 x 7/8” Button Head machine screws
F.
60x Nylon Washers
G.
16x ¼-20 Lock Nuts
H.
4x Hinges
I.
24x #12 Pan Head Wood Screws
Step 1. Assemble the pivot bracket assembly. (See Fig. 1)
Each pivot bracket assembly consists of 2x Pivot Arms (A) and 1x
Pivot Arm Connector (B). Use two ¼-20 bolts (E), 4 nylon washers (F),
and two lock nuts (G). Tighten hardware until snug then loosen roughly
¼ turn or until parts move freely but without slop.
Step 2. Install the Z-brackets onto each leg of your Heavy Duty
Tool Stand. (See Fig. 2)
Use the carriage bolts and lock nuts included with the stand to attach
the Z-brackets (C). Use 4 nylon washers (F) on each bracket between
the bracket itself and the stands leg to allow smooth adjustment. Leave
hardware hand tight. Be sure to install the mounting bolts through the
top two holes in the stands upper leg section as shown in Fig. 2 or the
extension table will not sit parallel with the router table tip.
CUTTING TOOLS
™
Infinity Router Table Extension Wings Instructions,
Part # RTEW-001
310 Mears Blvd • Oldsmar, FL 34677
P: 813-881-9090 | 1-877-872-2487 - Order Online 24/7: InfinityTools.com
