11
Ordercode: 41560
Infinity iM-2515
Multiple Infinitys (ArtNet control)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Use a CAT-5/CAT-6 cable to connect your ArtNet controller to the first unit’s Ethernet "in" socket.
04)
Link all the Infinitys by connecting the first unit's Ethernet "out" socket with the second unit's "in"
socket, using a CAT-5/CAT-6 cable.
05)
Repeat this process to link the second, third, and fourth units (fig. 05).
06)
Supply electric power: Plug electric mains power cords into each unit's PowerCON socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Infinitys ArtNet Set Up
Fig. 05
Note : Link all cables before connecting electric power
