TOOLS FOR ASSEMBLY
bicycle, call the service line direct at:
Tools Required:
•
Phillips head screw driver
•
4mm, 5mm, 6mm and 8mm Allen keys
•
Adjustable wrench or a 9mm, 10mm, 14mm and 15mm open and box end wrenches
•
A pair of plier
GETTING STARTED
Op
wrapping from the bicycle. Inspect the bicycle and all accessories and parts for possible
shortages. It is recommended that the threads and all moving parts in the parts package
be lubrica
complete to ensure that no required parts are accidentally discarded. Assemble your
bicycle following the steps that pertain to your model.
NOTE: Y
ones illustrated.
HANDLEBAR ASSEMBLY
Remo
Turn the fork of the bicycle to face forward. Note that “forward” means that the wheel
the fork when assembled.
Check handlebar st
handlebar can not move. The angle of the handlebar can be adjusted. To adjust; loosen
all of the handlebar stem clamping bolts, and rotate the handlebar to the desired angle.
Be sure tha
t the gap between the stem cap and stem stays even. Repeat
Models with gear and/or brake cables:
Locate the handlebar assembly. If your model bicycle comes equipped with gears
and/or handbr
properly r
tak
lever to the front brake or cable stop on the frame. If they are twisted or kinked, the
taking the smoothest route.
Correct
Incorrect
Correct
Incorrect
www.infinitycycleworks.com
copyright 2018 - Infinity Cycle Works Ltd.
Using the provided hex wrench, remove the four screws holding the stem clamp in place (Fig. A).
Place and center handlebars within the stem (some have centerline marks), and replace screws
(Fig. B).
Tighten with the provided hex wrench (Fig. C). Make sure that the gap between the stem is
roughly the same on the top and bottom (Fig. D, i), and the handlebars are at a comfortable
riding angle (Fig. d, ii).
A
B
C
D
ii
i
INFINITY MODEL:
Crazyhorse XM3 ST
Here is a picture of your assembled bicycle.
Be sure to double check that all bolts are
secure before riding.
Always wear a helmet.
