196
Infinity Chimp Series
Infinity Chimp Series
When the Cuelist is in Learn Timing Mode, the current Cue’s color will be indicated with a magenta
background color, and each press of the Go button will cause the cuelist to add the time elapsed
between the start of this cue and the Go command to start the next Cue into the Trig Time field. If the
Cuelist is set to Timecode, it will set the Cue time to the Timecode that was received during the press of
the Go Button.
Timecode Mode
The
Go Cue
Button sets this cuelist into a “protective” mode, which is very useful when mixing different
triggers in a cuelist. The console will only go Cues with Timecodes, if the Cue before the timecoded cue is
output.
The
Goto Cue
Button causes the cuelist to always trigger the cue that matches the received timecode,
which might cause the console to jump in the cuelist depending of the received timecode time.
Start Timecode
The
Start Timecode
Text field can be used to quickly offset all timecode timings within a cuelist.
Settings for Chasers only
Chase Go Trigger
Speed Master Faders are used to synchronize Chasers to a given Master Speed clock. The console
supports up to 3 Speed Master Faders. They may either be set to BPM or Seconds (see “Show Wide
Settings – Setting Timing Defaults”).
For Chasers there are no individual Cue trigger settings. Instead the Chaser has a global Trigger source for
all Cues which can be selected in the Chaser Setup Menu. If a Chaser is set to trigger on a Master Speed
then each time a Cue has been started the Chaser will update the timing of the next Cue with the
current Master Speed Trigger Time. So in essence the Chaser will run with the same speed as the Master
Speed, but won't sync to it. If multiple Chasers are being run which trigger on the same Speed Master
then these Cuelist will all run with the same speed, but will be offset depending on the time they have
been started.
The Chaser behavior intentionally differs from Cuelists behavior regarding Speed Masters. If the user
whishes to change the Chaser behavior to match the Cuelist behavior, then it is also possible to configure
a Chaser to Sync to its trigger source. The Chaser therefore has a custom setting “Sync to Source” to
brigde the gap between Cuelist and Chaser trigger behavior.
Playback Order
This defines the Playback order of the cues in the Chaser.
Forward
is used as the default.
Settings are:
Forward
- The Chaser will be played forwards.
Backward
- The Chaser will be played back in reversed order.
Random
- The Chaser will be played back with the Cues in random order, using an algorithm which
assures that no cue will be shown twice during each cycle of the chase.
Chase Snap Value
This defines at which percentage of the crossfade parameters that are set to “Snap” in the library will
snap to the new value.
Playing back Cuelists
