Infinity 200010, Manual

Page: 45 / 52

44
Ordercode: 200010
TS-260C7 Profile Engine
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
If the light effect does not operate properly, refer servicing to a technician.
Suspect four potential problem areas as: factory reset, the power supply, the LEDs, the internal fuse.
01)
First try to reset the device to its original factory default settings
(14. Reset Factory Settings see page 27).
02) Power supply. Check that the unit is plugged into an appropriate power supply.
03) The LEDs. Return the Profile Engine to your Infinity dealer.
04) The internal fuse. Return the Profile Engine to your Infinity dealer.
05) If all of the above appears to be O.K., plug the unit in again.
06) If you are unable to determine the cause of the problem, do not open the Profile Engine, as this may
damage the unit and the warranty will become void.
07) Return the device to your Infinity dealer.
No Response to DMX
Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card malfunction.
01)
Check the DMX setting. Make sure that DMX addresses are correct.
02) Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03) Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.