InfiniSource ETC 100, Hardware Manual

Page: 65 / 234

TimeForce II Hardware Guide 53
Using the Model IQ 1000 IntelliClock
• Ethernet: Put a check mark in the DHCP option to use
Dynamic Host Configuration Protocol. Otherwise, enter the IP
Address where the clock can be reached. Remember to use
periods. If the clock can only be reached using a specific port
number, enter the appropriate port into the
Port Number field.
Leave this field blank to use the default port.
Note: These settings are specific to your network setup. Infini-
source cannot supply these settings.
• Serial: Select the Com Port that the clock is connected to from
the drop-down menu. Select “Auto Detect” to have the system
automatically determine which port the clock is connected to.
• Modem: In the Phone Number field, enter the phone number
of the line that the clock is connected to. Enter the number
exactly as you would dial it into a telephone, including any
necessary area code or extension numbers. Do not use dashes
or brackets.
Example: A phone number of (800) 555-4855 would be
entered as “18005554855.”
• Cellular: Put a check mark in the DHCP option to use
Dynamic Host Configuration Protocol. Otherwise, enter the IP
Address where the clock can be reached. Remember to use
periods. If the clock can only be reached using a specific port
number, enter the appropriate port into the
Port Number field.
Leave this field blank to use the default port.
Note: These settings are specific to your network setup. Infini-
source cannot supply these settings.
Before you can customize the information to be sent to the clock from
TimeForce II, you must first add the clock profile to the system. Click
on the [CREATE] icon located in the lower left-hand section of the
screen.