InfiniSource ETC 100, Hardware Manual

Page: 39 / 234

TimeForce II Hardware Guide 27
IntelliClock Setup Instructions
Serial Clocks
The IntelliClock should be placed in a convenient location where
employees typically enter and exit the work area. It includes a mounting
panel with four holes. Mounting screws are included. Once the mount-
ing panel is attached to the wall, the clock’s face can be snapped into
place and locked onto the mounting panel.
1. Attach the IntelliClock mounting panel to the wall with the pro-
vided mounting screws.
2. Connect the power cord to the bottom of the IntelliClock and plug it
into the closest available electrical (110-120 VAC) outlet.
Note: It is highly recommended that you place the time clock on a
battery backup or surge protector. Power surges can permanently
damage the clock.
3. Connect the RJ-11 connector of the cable (the one that looks like a
phone-jack) into the port labeled “PHONE/COMPUTER/DAISY”
on the bottom of the time clock.
4. Snap the IntelliClock face piece into place on the mounting panel
and lock it in with the two locks located on the bottom of the
mounting panel.
5. Connect the RS-232 end of the cable (the 9-pin D-Connector) into
an available serial port on your computer.
Modem Clocks
The IntelliClock includes a mounting panel with four holes. Mounting
screws are included. Once the mounting panel is attached to the wall,
the clock’s face can be snapped into place and locked onto the mounting
panel.
1. Attach the IntelliClock mounting panel to the wall with the pro-
vided mounting screws.
2. Connect the power cord to the bottom of the IntelliClock and plug it
into the closest available electrical (110-120 VAC) outlet.
Note: It is highly recommended that you place the time clock on a
battery backup or surge protector. Power surges can permanently
damage the clock.