TimeForce II Hardware Guide
183
Installing a Bell/Buzzer
Figure HARDWARE-6: IQ 1000 Bell Connection
10. The 3 holes in the IQ 1000 relay are labeled “N.O.,” “COM” and
“N.C.”
•
N.O. (Normally Open):
This circuit is normally open. When the
relay is activated the circuit closes, causing the bell or buzzer
to go off. A vast majority of our customers connect their bells
using this port, as opposed to using the “N.C.” port.
•
COM (Common):
One end of the positive wire is
always
inserted
into the Common port.
•
N.C. (Normally Closed):
This circuit is normally closed. When
the relay is activated the circuit opens, causing the bell or
buzzer to go off. In most cases, this port will not be used.
Summary of Contents for ETC 100
