174
Infinisource
Removing the Motherboard
2-Screw Card Reader:
1.
Remove the six screws connecting the back panel of the clock case
to the front-piece using a Phillips screw driver.
2.
Remove the back panel. The card reader will still be attached to the
back panel.
3.
Remove the four corner screws that secure the motherboard to the
inside of the case.
4.
Gently remove the motherboard from the case so that you can
unplug the cable from the motherboard. Make sure you discharge
any static from your body before touching the motherboard.
5.
Unplug the card reader and keypad cables (if so equipped). See Fig-
ure HARDWARE-1.
4-Screw Card Reader:
1.
Remove the six screws connecting the back panel of the clock case
to the clock front-piece using a Phillips screw driver.
2.
Remove the four screws that hold the card reader in place.
3.
Remove the back panel.
4.
Remove the four screws that secure the motherboard to the inside
of the case.
5.
Gently remove the motherboard from the case so that you can
unplug the cable from the motherboard. Make sure you discharge
any static from your body before touching the motherboard.
6.
Unplug the card reader and keypad cables (if so equipped). See Fig-
ure HARDWARE-1.
Summary of Contents for ETC 100
