TimeForce II Hardware Guide
125
Velocity Clocks
GLOBAL SECURITY
NOW: 3
0=AUTO, 1=MIN, 5=MAX
NEW SECURITY:
The default global security level is 3. Type in the new security level and
press the <ENTER> key.
Collecting Data
Punching in and out is very simple with the V800. Within the Time-
Force software, each employee is assigned a “Card Number.” This num-
ber corresponds with the number assigned to the employee’s finger tem-
plates stored in the time clock itself. If the V800 is ready to accept
punches, the word “Ready” appears in the display panel with the date
and time.
Time & Attendance Punches
Use the following instructions to enter basic time and attendance
punches at the clock (with no job, task or department information).
1.
Check to see that the clock display reads “Ready” with the date and
time displayed at the top of the screen. The “Company Message” is
also displayed, if applicable.
2.
Enter your card number at the clock keypad and press <ENTER>.
The display panel shows the card number and reads:
CARD #[X]
READING FINGER ID
PUT FINGER
ON SENSOR
3.
Place your finger on the template reader. To ensure correct place-
ment, the finger should be placed with the first joint of the finger
against the raised ridge at the base of the reader screen, and with the
fingertip pressed firmly against the screen. Once your finger ID has
been verified, the following message is displayed:
Summary of Contents for ETC 100
