InfiniSource ETC 100, Hardware Manual

Page: 119 / 234

TimeForce II Hardware Guide 107
Velocity Clocks
You can now exit the time clock menu by pressing <CLR> repeatedly
until the time is shown on the clock display.
Hardware Installation
Use the following instructions to place your time clock in the desired
location and to install communications with the clock. Follow the
instructions below that correspond with the type of communication that
your clock uses.
Note: See page page 111 for instructions on installing the V800/V850
Cellular Modem Clock.
The clock should be placed in a convenient location where employees
typically enter and exit the work area. It includes a mounting plate with
four holes. Mounting screws are included. Once the mounting plate is
attached to the wall and all cables are connected, the clock’s face can be
slid into place and secured to the mounting plate.
1. The clock is shipped with the mounting plate attached. Remove the
mounting plate from the clock and attach it to the wall with the pro-
vided mounting screws. The flat side should face to the left, with
the rounded side facing to the right.
Note: Removing the metal mounting plate from the back of the
time clock will not void your hardware warranty.
2. Connect the power cord to the bottom of the clock and plug it into
the closest available electrical (110-120 VAC) outlet.
Note: It is highly recommended that you place the time clock on a
battery backup or surge protector. Power surges can permanently
damage the clock. For instruction on connecting an Ethernet PoE
clock, see page 189.
3. Connect the clock’s communications cable. Use the instructions
below that correspond with your clock’s communication type.
Ethernet Clocks
• The Ethernet port is located in the top center of the back of the
clock. Plug one end of the Standard Category 5 (CAT5) cable
into the Ethernet port.