![Infineon XENSIV CSK PAS CO2 User Manual Download Page 30](http://html1.mh-extra.com/html/infineon/xensiv-csk-pas-co2/xensiv-csk-pas-co2_user-manual_2055409030.webp)
30 of 54
2022-25-04
User Guide for XENSIV™ KIT PAS CO2
Hardware description
5.1.5
Serial interconnection between PSoC™ 5LP and module
In addition to its use as an on-
board programmer, the PSoC™ 5LP device functions as an interface for the USB
-
UART and USB-
I2C bridges. The serial pins of the PSoC™ 5LP device are hard
-wired to the I2C/UART pins of the
PSoC™ 6 MCU
device.
Figure 29
KitProg3 interface
5.1.6
Power supply system
The kit has the following input voltage sources:
•
5 V from KitProg3 USB Micro-B port (J4)
•
LiPo battery @ 3.7 V, 350 mAh (J3)
Figure 30
USB connector
The LiPo battery is connected to the LiPo battery charger IC (U10) with a 10µF bypass capacitor. The LiPo battery
charger takes the VBUS (5V) from the USB connector (J4) as a source for charging the battery as well as the supply
(VOUT) for other components when battery power is not available. A yellow LED (LED5) attached to the
pin
of the charger IC indicates the battery charging status by glowing continuously. It automatically turns off when
the battery is fully charged. The TS pin is meant for an external negative temperature coefficient (NTC)