Technical Reference Manual
002-29852 Rev. *B
26.8.46 CSV_HF
26.8.46.1 CSV
26.8.46.1.1 CSV_HF_CSV_REF_CTL
Description:
Clock Supervision Reference Control
Address:
0x40261400
Offset:
0x0
Retention:
Retained
IsDeepSleep:
No
Comment:
Controls clock supervision for a clock tree.
Default:
0x0
Bit-field Table
Bits
7
6
5
4
3
2
1
0
Name
STARTUP [7:0]
Bits
15
14
13
12
11
10
9
8
Name
STARTUP [15:8]
Bits
23
22
21
20
19
18
17
16
Name
None [23:16]
Bits
31
30
29
28
27
26
25
24
Name
CSV_EN
[31:31]
CSV
_ACTION
[30:30]
None [29:24]
Bit-fields
Bits Name
SW
HW
Default or
Enum
Description
0:15
STARTUP
RW
R
0
Startup delay time -1 (in reference clock cycles), after
enable or DeepSleep wakeup, from reference clock
start to monitored clock start.
At a minimum (both clocks running): STARTUP >=
(3) * FREQ_RATIO - UPPER, with
FREQ_RATIO = (Reference frequency / Monitored
frequency)
On top of that the actual clock startup delay and the
margin for accuracy of both clocks must be added.
30
CSV_ACTION
RW
R
0
Specifies the action taken when an anomaly is
detected on the monitored clock. CSV in DeepSleep
domain always do a Fault report (which also wakes up
the system).
FAULT
0
Do a Fault report.
RESET
1
Cause a power reset. This should only be used for
clk_hf0.
31
CSV_EN
RW
R
0
Enables clock supervision, both frequency and loss.
CSV in Active domain: Clock supervision is reset
during DeepSleep and Hibernate modes. When
enabled it begins operating automatically after a
DeepSleep wakeup, but it must be reconfigured after
Hibernate wakeup.
CSV in DeepSleep domain: Clock supervision is reset
during Hibernate mode. It must be reconfigured after
Hibernate wakeup.
A CSV error detection is reported to the Fault
structure, or instead it can generate a power reset.
1692
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers