User Guide
24 of 44
Revision 1.1
2021-03-21
EVAL-M3-302F User Guide
iMOTION™ Modular Application Design Kit
Getting started with EVAL-M3-302F
IMC302A-F064 controller, the 3.3 V DC voltage needs to be supplied to the controller portion of the
EVAL-M3-302F. This voltage can either be supplied by the power board (MADK power boards are
designed to supply the 3.3 V to the control board through M1 or M3 connector) or by feeding the 3.3
V DC voltage to the control board through some of the available 3.3 V access/test points, if the
power board is not attached to the EVAL-M3-302F control board.
All the latest firmware files for different types of iMOTION
TM
control ICs are available for download via Infineon
iMOTION
TM
website (
http://www.infineon.com/imotion-software
).
5.2
Working with the MCU
The microcontroller in the IMC302A-F064 is based on an Arm® Cortex® M0 core allowing the use of a wide range
of development tools and available software solutions.
Connection to the MCU is offered via the standard serial wire debug (SWD). The SWD interface is routed via the
galvanic isolation to the on-board interface. The debug interface is based on Segger® J-Link technology. The
respective DLL is installed on the PC during installation of the above-mentioned iMOTION tools, namely the
MCEDesigner. Alternatively, the installation of the respective driver can be updated from the Segger website.
Configuring, setting up and programming the embedded MCU is beyond the scope of this User Guide. Please
refer to the Hardware Reference Manual of the IMC300 series and the CMSIS pack.
