Inficon ULTRATEST UL3000 Fab, Translation Of The Original Operating Instructions

Page: 63 / 140

INFICON Operation | 6
UL3000-Fab-Operating-instructions-iina73en1-08-(1910) 63 / 140
At least one range must be activated.
ü
Operator or Supervisor rights
1
> Setup > Measurement > Vacuum > Vacuum ranges
2
Activate the desired vacuum range under "Vacuum range".
3
Save .
6.3.5 Set Auto Leak Test
Please take note of the information on the operation mode "Auto Leak Test" and the
notes on measuring. See also Operation mode “Auto Leak Test” [ } 18], “Select
operation mode [
}
61]”, “Measuring [
}
74]” and “Result display of the Auto Leak Test
[
}
55]”.
ü
Operator or Supervisor rights
1
> Setup > Measurement > Vacuum > Auto Leak Test
ð
You can edit the following settings:
- “Min. Test time”
- “Max. test time”
- “Leak rate setpoint 1”: To change the setpoint 1. The same threshold value
can alternatively be set in the window "Setpoint values", see “Setting
setpoints [
}
62]”.
- “Part numbering”: After activating this function, a number is assigned for
each test. This facilitates the traceability of test results, see “Call result log
[
}
81]”.
- “Part number”: To assign a part number. For each measurement, this partial
number is counted as starting number.
- “Warning limit for consecutive failed tests”: After the entered number has
been reached, a warning message is displayed.
2 Set up.
3 Save .
6.3.5.1 Consider the background of the test chamber
If unexpected results, such as many failed tests are displayed in succession, we
recommend performing a "Reference measurement". You can repeat such a
measurement at regular intervals.
ü
Test chamber is mounted, empty and closed.
ü
Operation mode “Auto Leak Test“
ü
Device is in the "Standby" state.
1 Select the cross-hair icon .
2 Select "Reference measurement".
3 Press .